Waterford-appliances NATURAL GAS E61-LP Manual de usuario descargar pdf (Pagina 15)

15Waterford E61 Gas Fireplace Insert

OPERATING INSTRUCTIONS

OPERATING

INSTRUCTIONS

Before operating this appliance, proceed

through the following check list.

1) Read and understand these Instructions

before operating this appliance.

2) Check to see that all wiring is correct and

enclosed to prevent possible shock.

3) Check to ensure there are no gas leaks.

4) Make sure the three door glass pieces are

in place. Never operate the appliance with

any of the door glass removed or with the

door open. Do not strike the glass or slam

the door shut.

WARNING: Do not operate appli-

ance with glass front removed,

cracked or broken. Replacement of

the glass should be done by a li-

censed or qualified service person.

5) Verify that all venting and the cap is unob-

structed.

6) Verify log placement. If the pilot cannot be

seen when lighting the unit - the logs or the

embers have been incorrectly positioned.

7) The unit should never to turned off and on

without a minimum of a 60 second wait.

8) When lighting the appliance, the inside of

the glass may fog up. This will burn off after

a few minutes of operation.

DO NOT BURN THE APPLIANCE

WITH THE DOOR OPEN.

LIGHTING PROCEDURE

IMPORTANT: Gas cock knob cannot be turned

from "PILOT" to "OFF" unless it is partially

depressed.

1) Open the lower grill.

2) If the control knob is set to "OFF" proceed

to Step 4.

3) Push in gas control knob slightly and turn

clockwise to "OFF".

4) Wait five minutes to allow gas, that may

have accumulated in the main burner com-

partment, to escape. If you do smell gas,

follow the instructions on the front of this

manual. If you don't smell gas continue on

to the next step.

5) Turn the gas control counterclockwise to

"PILOT". Knob cannot be turned from "PI-

LOT" to "OFF" unless knob is pushed in

slightly. Do not force.

6) Push in control knob all the way and hold in.

Immediately push black button on spark

igniter until pilot lights. Continue to hold the

control knob in for approximately one

minute, then release the gas control knob.

The pilot flame should continue to burn. If

the pilot does not remain lit, repeat opera-

tion allowing a longer period before releas-

ing gas control knob.

7) Turn gas control knob counterclockwise to

"ON".

8) Use rocker switch to operate main burner.

9) Rotate the variable flame control to adjust

the flame height higher or lower.

10)Close the lower grill.

11)The door must be closed when operating

the unit.

SHUTDOWN

PROCEDURE

1) Use the rocker switch to turn off the main

burner.

2) Open the lower grill.

3) Push in the gas control knob slightly and

turn clockwise to "OFF". Do not force.

4) Disconnect all electric power to the appli-

ance if service is to be performed.

FIRST FIRE

The first fire in your stove is part of the paint

curing process. To ensure that the paint is

properly cured, it is recommended that you

burn your fireplace for at least four (4) hours

the first time you use it with the fan on.

When first operated, the unit will release an

odour caused by the curing of the paint, the

burning off of any oils remaining from manufac-

turing. Smoke detectors in the house may go off

at this time. Open a few windows to ventilate

the room for a couple of hours.

The glass panel may require cleaning after the

unit has cooled down. DO NOT ATTEMPT TO

CLEAN THE GLASS WHILE IT IS HOT.

AUTOMATIC

CONVECTION FAN

OPERATION

The fan operates automatically, turn the knob on

the side of the faceplate to adjust to the desired

speed. The fan will turn on as the stove comes

up to operating temperature. After the unit has

been turned off and the unit cooled to below a

useful heat output range the fan will shut off

automatically.

NORMAL OPERATING

SOUNDS OF

GAS APPLIANCES

It is possible that you will hear some sounds

from your gas appliance. This is perfectly nor-

mal due to the fact that there are various gauges

and types of steel used within your appliance.

Listed below are some examples. All are nor-

mal operating sounds and should not be

considered as defects in your appliance.

Blower:

Waterford gas appliances use high tech blow-

ers to push heated air farther into the room. It is

not unusual for the fan to make a "whirring"

sound when ON. This sound will increase or

decrease in volume depending on the speed

setting of your fan speed control.

Burner Tray:

The burner tray is positioned directly under the

burner and logs and is made of a different gauge

material from the rest of the firebox and body.

Therefore, the varying thicknesses of steel will

expand and contract at slightly different rates

which can cause "ticking" and "cracking"

sounds. You should also be aware that as there

are temperature changes within the unit these

sounds will likely re-occur. Again, this is normal

for steel fireboxes.

Blower Thermodisc:

When this thermally activated switch turns ON

it will create a small "clicking" sound. This is the

switch contacts closing and is normal.

Pilot Flame:

While the pilot flame is on it can make a very slight

"whisper" sound.

During the first few fires, a white film

may develop on the glass front as part

of the curing process. The glass should

be cleaned or the film will bake on and

become very difficult to remove. Use a

non-abrasive cleaner and NEVER clean

the glass while it is hot.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Comentarios a estos manuales

Sin comentarios

Waterford-appliances NATURAL GAS E61-LP Manual de usuario Pagina 15

Comentarios a estos manuales